Then perhaps a good idea is to look at the sourcecode for. If it is also broken the same way for 32-bits). While the wine asio dll is selected in the configuration. Without resorting to midi coming from jackd or alsa. This midi bug seems to occur under wine / ableton 10 if I just use the standard computer keyboard. then that might tell us something a bit more useful. So if you are experiencing this same MIDI problem with Live 9 then it would be interesting to know if your Live 9 (and the wine asio dll for it !) was 32-bits or 64-bits.īecause if it works on Live 9 under 32-bits (but not 64-bits). I read on Ableton's FAQ that Live 10 is a 64-bit only application. I did not use the program 'cadence' but everything else seems pretty similar. Again, i can see ableton registering the midi event with the little indicator in the top right corner of the screen, but it's broken on the channel / buses. And get a similar problem over here.Ībleton 10.0.1 + Jack2 (1.9.12) and jack is using alsa, compiled the wine asio dll. If this article hasn't helped you, please feel free to search again at the top of this page or, to contact support, please click here.Tried this for the first time today. Logic will see all available inputs and outputs automatically. Outputs can be added by going to Activate Output Channels > Channels Inputs can be added by going to Activate Input Channels > Channels. To add outputs, use the Output Buses option. Each input can be added via the 'Input Buses' section. In Bitwig, navigate to Options > Preferences > Audio. The same applies to the output side of things. You can then select the 'range' (first and last output) here. In Reaper, navigate to Options > Preferences > Audio > Device. The same applies to adding outputs, which can be done via the ‘Output’ tab. You can select ‘Add (Mono)' which will add a single input, or ‘Add (Stereo)’ which will group a pair of inputs together. Navigate to ‘Studio One’ > Preferences > Song Setup > Audio I/O Setup. The same applies to adding outputs, which can be done via the Output tab. You can create a mono bus, which will add a single input, or a stereo bus, which will group a pair of inputs together. Each input of your Focusrite interface can be added by clicking on ‘Add Bus’. Once the project has been created, go to Devices > VST Connections. The same applies to adding outputs, which can be done via the ‘Output Config’ tab. (Ableton Live Lite limits you to the first four inputs of any interface.) Here is where you can add each input of your Focusrite interface. Next to ‘Channel Configuration’ click on ‘Input Config’. You can add each input of your Focusrite device by clicking ‘New Path’. Once you've created a project, go to Setup > I/O > Input.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |